MaxTech PCN2000 Series Uživatelský manuál stáhnout pdf (Strana 29)

Imaging Utilities and Options 235

Novell Confidential Manual (99a) 11 September 2003

To use the ZENPartition mode:

1 Enter img to display a menu > select ZENPartition > read the text that displays > select

Continue > select an operation > OK.

Enter the following:

img zenPartition operation

where operation is enable, disable, or remove.

2 Enter lilo.s to make this change effective.

IMPORTANT: If you remove an installed ZfD imaging partition, you must immediately restore a base image

with a valid non-LILO MBR (Master Boot Record). If you do not, the computer will not be able to boot properly.

Information Mode

Use the Information mode to view the following:

 Information about the hardware devices on the computer

This information is detected during the imaging bootup process. If the imaging engine runs in

auto-imaging mode, this information is sent to the imaging server to help determine which

image to put on the computer, if necessary.

 The data currently stored in the image-safe area on the computer

This data is saved by the imaging agent during each Windows session to ensure that it can be

restored after the computer is reimaged. If the computer is new and doesn’t have Windows

yet, an initial set of data is supplied from an NDS policy via the imaging server to the imaging

engine when the first base Windows image is laid down.

 Name of the base image that was last laid down on the computer

To use the Information mode:

1 Enter img to display a menu > select Information > select All, Hardware, or ZISD. See the

table below for details.

Enter the following:

img info [zisd]

Parameter Specifies to

info List the detected hardware devices on the computer, including:

 CPU chipset

 Video adapter

 Network adapter

 MAC address

 Sound card

 Hard drive controller

 Hard disk capacity

 RAM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Žádné komentáře

MaxTech PCN2000 Series Uživatelský manuál Strana 29