MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem Uživatelský manuál stáhnout pdf (Strana 21)

NOTICE: The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the sum of the Load Numbers of all the devices does not exceed 100.

UL Notice

Caution: This internal modem adapter is to be installed in UL Listed computers only, Always disconnect the modem adapter from the telephone system during installation or when the cover is removed from the computer.

First EditionGZ/DR - Version 1.0

1 2 ... 16 17 18 19 20 21 22 23

User's Manual 1
Section One - Introduction 3
Section Two - Installation 3
2.3 Hardware Installation 4
2.8 Using Your Modem 8
2.9 Where To Go From Here 8
3.1 Executing Commands 9
3.2 Command Structure 9
3.3 Basic AT Commands 9
3.4 Extended AT Commands 11
3.5 MNP/V.42/V.42bis Commands 12
3.6 Fax Class 1 Commands 14
3.7 Fax Class 2 Commands 14
3.8 SVD Commands 15
Section Four - S Registers 16
Section Five - Result Codes 17
Section Six - Troubleshooting 17
Appendix A - Specifications 18
Appendix B - Notices 19
FCC Class B Statement 20
DOC Compliance Information 20
UL Notice 21

Komentáře k této Příručce

Žádné komentáře

MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem Uživatelský manuál Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Modemy MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem